0x01

BCC Clear all calls or do not clear all calls when both C Channels are dead when switchover failure occurs.

*0x00 = BCC Clear All Calls
0x01 = BCC Do not clear all calls

0x02

PCM Encoding Format

0x01 = MU Law Encoded PCM
*0x02 = A Law Encoded PCM
0x03 = Mixed Encoded PCM
0x01 = DS2 A Law Encoded PCM

0x03

Wait for Startup Request from host, when Layer Manager receives Startup Fail from System Management

*0x00 = Do not wait
0x01 = Wait

0x04

Type of Port Alignment

Important! When this Config Byte is set to 2, the other side must be intelligent enough to send block indications to the ports that are locally blocked.

0x00 = Unblock all user ports, then block
locally-blocked ports
*0x01 = Perform accelerated port alignment procedure, then block locally-blocked ports
0x02 = Block locally-blocked ports

0x05

Send Reset Sequence Number during
startup procedure

*0x00 = Do not send
0x01 = Send

0x06

Send all Status Indications to the host

*0x00 = Send only relevant Status Indications
0x01 = Send all Status Indications (used for diagnostics purposes only)

0x07

Enable Port Alignment Procedure

0x00 = Disabled (LE default)
*0x01 = Enabled (AN default)

0x08

Link blocking action after startup

0x00 = Do not send block or unblock links (links will default to operation for the first startup)
*0x01 = Send block link only for links that are locally blocked
0x02 = Send both unblock or block for all links depending on previous link status

0x09

Layer Manager Mode

*0x00 = Non-protective Mode
0x01 = Protective Mode