L3P PSTN Configuration Bytes

Byte

Description

Values (* Default)

0x01

Send optional SIGNAL message (with steady
signal=Rev Polarity) upon off-hook.

* 0x00 = Send SIGNAL message
0x01 = Do not send SIGNAL message

0x02

Send optional SIGNAL message (with steady
signal=Normal Polarity) upon on-hook.

* 0x00 = Send SIGNAL message
0x01 = Do not send SIGNAL message

0x03

Deallocation option upon receiving Call Clearing message (send Channel Remove to BCC upon receiving on-hook, DISCONNECT or DISCONNECT COMPLETE)

* 0x00 = Send Channel Remove to BCC
0x01 = Do not send Channel Remove to BCC

0x04

Deallocation option upon sending
DISCONNECT (LE side only)

* 0x00 = Send Channel Remove to BCC
0x01 = Do not send Channel Remove to BCC

0x05

Call Collision Priority

* 0x00 = Incoming call has priority
0x01 = Outgoing call has priority

0x06

Number of digits to receive before sending the SETUP Indication

Default = 10 digits

0x07

Request For Service Format

* 0x03 = V5 Formatted ICB

0x08

Specified the connected PPL state for PSTN

* 0x04

0x09

Config. Byte offset to IE Table. First Byte is
number of IEs in table.

* 0x32

0x0A

Calling Party Control

0x00

0x0B

Send L3 ESTABLISH Indication to L5

* 0x00 = Do not send PPL Event Indication
0x01 = Send PPL Event Indication

0x0C

Reserved

 

0x0D

Send L3 SIGNAL Indication to L5

* 0x00 = Do not send PPL Event Indication
0x01 = Send PPL Event Indication

0x0E

Send L3 STATUS Indication to L5

* 0x00 = Do not send PPL Event Indication
0x01 = Send PPL Event Indication

0x0F

Reserved

 

0x10

Reserved

 

0x11

Reserved

 

0x12

Send L3 PROTOCOL PARAMETER
Indication to L5

* 0x00 = Do not send PPL Event Indication
0x01 = Send PPL Event Indication

0x14

Send SIGNAL messages with digit info for Called Party

* 0x00 = Do not send SIGNAL message
0x01 = Send SIGNAL message

0x15

Pulse Notification IE included in last SIGNAL message (Overlap Sending Option).

* 0x00 = Include
0x01 = Do not include

0x16

Stores Pulse Duration Type value Pulsed-Signal IE (FLASH Request)

* 0x00

0x17

Stores Suppression Ind. value Pulsed-Signal IE (FLASH Request)

* 0x00

0x18

Stores Acknowledge Request Ind. value for Pulsed-Signal IE (FLASH Request)

* 0x00

0x1A

Do not wait for SIGNAL messages with CLD (called) party number digits before sending SETUP Indication to L4

* 0x00 = Wait for digits
0x01 = Do not wait for digits

0x1B

Default Pulse Type to indicate a Switch Hook Flash

* 0x76 = Register Recall

0x20

Ringback Tone Option

* 0x00 = Do not play Ringback
0x01 = Send PPL Event Indication

* 0x00 = Do not play Ringback
0x01 = Do play Ringback (make sure DSP card is configured with correct function type).