You are here: CSP Developer’s Guide: Internet Protocol > 3 IP Network Interface Series 2 Card > Host/IP Network Interface Series 2 Card Integration Information
Host/IP Network Interface Series 2 Card Integration Information
The following table defines the basic information a host needs to integrate the IP Network Interface Series 2 card into a CSP.
Table 3-1 Host/IP Network Interface Series 2 Card Integration Information
Product Name |
IP Network Interface Series 2 Card |
IP Network Interface Series 2 card ID |
101 (0x65) |
IP Network Interface Series 2 card VoIP Module Board ID |
104 (0x6D) |
Multi-Function Media I/O card ID |
202 (0xCA) |
L3 PPL Component ID |
159 (0x9F) |
L3 PPL Protocol ID |
BOOT Protocol = 11 (0x0B) |
Host L3 PPL Download Support |
Host Downloadable PPL Tables are not supported |
TFTP Additions |
VOCCVOIP_LOAD = vocc_ip.bin* = SAVE_LOAD_FALSE Important! *The actual .bin file names change off of the build release. |
Default Resource Profile |
G.711+G.726+ G.723.1+G.729A/B+T.38 (Profile 2) |
Default Gateway Mode |
Gateway Mode |
PCM Companding Law |
m-Law |
Control Interface |
The IP Network Interface Series 2 card is controlled by the Matrix Controller Series 3 card using the API message set. |
Data Interface
|
VoIP data is transported using the three external 100Base-T (100 Mbps) Ethernet ports on the Multi-Function Media I/O card. All three ports are configured as a single Link Aggregate Group (LAG), extending the total bandwidth to 300 Mbps and providing automatic link redundancy. If interfaced with a LAG compatible Ethernet Switch, all three ports can be utilized. If not, only ONE of the three ports can be connected to the Ethernet network, if LAG is not used. |