Byte |
Description |
Values (* Default) |
---|---|---|
0x01 |
BCC Clear all calls or do not clear all calls when both C Channels are dead when switchover failure occurs. |
*0x00 = BCC Clear All Calls |
0x02 |
PCM Encoding Format |
0x01 = MU Law Encoded PCM |
0x03 |
Wait for Startup Request from host, when Layer Manager receives Startup Fail from System Management |
*0x00 = Do not wait |
0x04 |
Type of Port Alignment Important! When this Config Byte is set to 2, the other side must be intelligent enough to send block indications to the ports that are locally blocked. |
0x00 = Unblock all user ports, then block |
0x05 |
Send Reset Sequence Number during |
*0x00 = Do not send |
0x06 |
Send all Status Indications to the host |
*0x00 = Send only relevant Status Indications |
0x07 |
Enable Port Alignment Procedure |
0x00 = Disabled (LE default) |
0x08 |
Link blocking action after startup |
0x00 = Do not send block or unblock links (links will default to operation for the first startup) |
0x09 |
Layer Manager Mode |
*0x00 = Non-protective Mode |