Default Instruction Lists

Default Inseize Instruction List

The default inseize instruction lists for E1 spans are shown in the table below.

Channel

Instruction List

E1

1. Generate Inseize ACK
2. Receive Stage 1 Address Data
3. Report Incoming Call With Digit
4. Wait For Host Control Message

Default Outseize Instruction Lists

The default outseize instruction lists for E1 spans are shown in the table below.

Channel

Instruction List

E1

1. Outpulse Stage 1 Digits
2. Outpulse Stage 2 Digits
3. Outpulse Stage 3 Digits
4. Outpulse Stage 4 Digits
5. Report Call Processing Event
6. Wait For Host Control Message

Configuring Instruction Lists

You must send a separate message for each instruction you add to the list. For example, to configure the following inseize instruction list on all of the channels on Span 0, send the following sequence of Inseize Instruction List Configure messages, with the specifications noted:

Instruction List

1. Generate Wink 1

2. Receive Stage 1 Digits

3. Report Incoming Call with Address Data

4. Wait for Host Control

 

Send the following Inseize Instruction List Configure messages:

Message 1:

Instruction Number: 0x01
Instruction Type: 0x02 (Generate Call Processing Event)
Instruction Data Byte 1: 0x03 (Wink 1)

Message 2:

Instruction Number: 0x02
Instruction Type: 0x03 (Receive Stage N Address Data)
Instruction Data Byte 1: 0x01 (Stage 1)

Message 3:

Instruction Number: 0x03
Instruction Type: 0x06 (Report Incoming Call With
Address Data)

Message 4:

Instruction Number: 0x04
Instruction Type: 0x04 (Wait For Host Control)