Installing the SNMP Agent on Windows

This procedure describes the installation of the SNMP Agent on a Windows system.

Before you begin

EXS SwitchKit must be installed before you start the SNMP installation. Please refer to the installation instructions in the EXS SwitchKit Installation and Maintenance Guide.

If you have a previous version of the SNMP Agent installed on your system, you must first remove that installation with the Add/Remove Programs utility under the Control Panel.

Installing SNMP on Windows

To install the SNMP Agent, follow the steps below:

You must reboot your system after the installation in order to run all SNMP Agent components properly.

1 Log on to your target machine with an administrative account.

2 Insert the EXS SwitchKit Installation CD. In the folder: /snmp/windowsnt; double-click the file cspSnmp.exe to start the installation. During the installation, the following environment variables are created on your system:

• SR_MGR_CONF_DIR

• SR_AGT_CONF_DIR

• SR_BIN_CONF_DIR

3 Refer to the verification procedures after the installation is finished.

4 Reboot your machine.