You are here: CSP API Reference > 3 Information Control Blocks > Action ICBs
Most hex IDs are used to represent more than one Action ICB. Two or more ICBs with the same number are never used in the same API message. ICBs marked with an asterisk (*) contain no data, so their data length is zero (0x00) and there is no table in this section.
Hex |
Action ICB Name |
Used in These Messages |
0x00 |
Null* |
Inseize Control, Route Control, Outseize Control |
0x01 |
Free System Resources |
Connect With Data |
Report Call Processing Event |
Inseize Control |
|
Scan For Wink N |
Route Control, Outseize Control |
|
0x02 |
Release Mode Configure |
Connect With Data |
Generate Call Processing Event |
Inseize Control |
|
Scan For ANI Request Off-hook* |
Route Control, Outseize Control |
|
0x03 |
Receive Stage N Address Data |
Inseize Control |
Scan For Dial Tone* |
Route Control, Outseize Control |
|
0x04 |
Wait For Host Control* |
Inseize Control |
Report Call Processing Event |
Route Control, Outseize Control |
|
0x05 |
Report Incoming Call* |
Inseize Control |
Outpulse Stage N Address Data |
Route Control, Outseize Control |
|
0x06 |
Report Incoming Call With Address Digits* |
Inseize Control |
Wait For Host Address Data* |
Route Control, Outseize Control |
|
0x07 |
Generate Inseizure Acknowledgment* |
Inseize Control |
Wait For Host Control* |
Route Control, Outseize Control |
|
Query Load Version |
TFTP Manage |
|
0x08 |
Send Host Acknowledgment* |
Inseize Control, Route Control, Outseize Control |
Query Load Filename |
TFTP Manage |
|
0x09 |
Use Instruction List |
Inseize Control |
|
Do Call Progress Analysis |
Route Control, Outseize Control |
0x0A |
Delay N Milliseconds |
Inseize Control |
Seize* |
Route Control, Outseize Control |
|
0x0B |
Use Instruction List |
Route Control, Outseize Control |
0x0D |
Cancel R2 Receiver* |
Route Control, Outseize Control |
0x0E |
Scan For Backward R2 Signal* |
Route Control, Outseize Control |
0x0F |
Wait For Host Control |
Route Control, Outseize Control |
0x10 |
Do CPA Without Line Signaling* |
Route Control, Outseize Control |
0x11 |
Delay N Milliseconds |
Route Control, Outseize Control |
0x33 |
Enable Multi-Host* |
Multi-Host Control |
0x34 |
Disable Multi-Host* |
Multi-Host Control |
0x35 |
Host Query Message Registration |
Multi-Host Control |
0x36 |
Connections Query* |
Multi-Host Control |
0x37 |
Local Matrix Controller Configuration Filename |
Multi-Host Control
|
0x38 |
Query Hard-registered PPL Components |
Multi-Host Control |
0x39 |
Query Soft-registered PPL Components |
Multi-Host Control |
0x01 Report Call Processing Event
0x02 Generate Call Processing Event
0x03 Receive Stage N Address Data
0x04 Report Call Processing Event
0x05 Outpulse Stage N Address Data
0x09 Do Call Progress Analysis
0x10 Do Call Progress Analysis Without Line Signaling
0x35 Query Host Message Registration