Technical Helpweb

- more articles

Eiconcard S90, S91 and S94 Installation

The following Dialogic® Eiconcard™ boards require the use of the drivers "Eiconcard Connections for Windows" which are available via our product page
  • C30
  • C31
  • C90
  • C91
  • CX1
  • S92
  • S94 8MB (Part number - 310-208-03)

The following installation was carried out using an S91 card.

(Note: This installation procedure also applies to C20 and C21 cards)

The S91 card will appear as a 'Network Adapter' entry in Device Manager.





Using the WAN Services Configuration Program


Start the Eiconcard configuration program by any of the following methods:
  • Running ECADMIN at a command prompt (use full path of <drive:>\winnt\system32\eicon)
  • From Start > Programs > Dialogic > Eicon Cards > Eicon Configuration Program
  • From the 'Advanced Properties' of the Eiconcard in Device Manager

After loading you will see:



Step 2. Configure the Eiconcard adapter options according to your requirements. Then click on a card icon to show high level protocols and ports.

Step 3. Configure the high level protocols as required.



NOTE: Generally these values should not be modified unless your specific application gives instructions to do so.

Step 4. Configure each of the ports as required.



Step 5. After finishing configuring all the ports, select the "Save" option form the File menu and then "Exit" to complete the Core Services Configuration.




Feedback

Please rate the usefulness of this page:  
0 - not useful at all
1 - potentially useful
2 - quite useful
3 - very useful
4 - exactly the information I needed     

Please enter a comment about this page:
First published: 10-May-2011
Open access: Product rule: ; Page rule: Auto

Service Center Logon